![]() ![]() To confirm, press Open, Close, or move to % to verify that the treatment now moves to this position.Based of the recommendations from the Inexpensive shades or blinds thread I recently installed the Bali Z-Wave shades in my home I purchased from Costco and connected them via Vera. ZWAVE SHADE CONTROL FULLYou will now have full control of the shade with your Z-Wave controller. Repeat these steps for any additional shades and micromodules you would like to control. The shade will move up and down several times so that the module can learn its upper and lower limits. ![]() ![]() To do so, press and hold the button on the micromodule for 3-5 seconds and then release it. Once you’re certain that the directions and limits are correct, you will need to calibrate the micromodule to the shade. Make sure to re-apply power once the wires have been swapped.ģ If the limits need to be adjusted, refer to the shade fabricator’s or the motor manufacturer’s instructions. You will then need to press the button on the micromodule three times while on step 3 of these instructions.Ģ If the shade runs in reverse, power down the micromodule and swap the red and black wires coming from the motor. While it displays “Looking for devices” quickly press the button on the micromodule three times. Tap on the hub, select Z-Wave Utilities, followed by General Z-Wave Exclusion. Tap on the hamburger menu icon in the top left of the app. 3ġ If the micromodule has already been powered or was part of a previous Z-Wave network, you will need to perform an exclusion with the Smartthings hub. 2 Also, make sure that the shade stops at the correct upper and lower limits. Click on Open or Close to ensure that the shade moves in the correct direction.Give the module approximately 60 seconds to complete provisioning before proceeding.It should learn into your SmartThings hub. When you see “Looking for devices” at the top of the page and there is a cicle on the screen, apply power to the micromodule.Scroll down your list of Things until you see “+ Add a Thing.” Tap on it.Perform the following steps to learn the micromodule into your SmartThings hub: If your shade has a metal fascia or a cassette, make sure that the antenna of the micromodule is outside of the metal to ensure optimal Z-Wave communication. Please note: Z-Wave is an RF communication. ZWAVE SHADE CONTROL INSTALLInstall the Zipato Micromodule Motor Controller, following the diagram below: Be sure that the shade is level to avoid any issues with the fabric “telescoping.” Install the shade per the fabricator’s instructions. If there’s no room for a standard outlet, your electrician can install a Sillites self-contained receptacle, SILSCRW. Although a bare wire with wire nuts can be used, to pass inspection, the electrician will likely need to terminate the AC line. It’s recommended that you have your electrician run an AC wire to the left side of the window. Zipato Micromodule motor controller, SKU ZIPPHPAN08US.Somfy-powered shade using a standard, 4-wire, AC motor. ZWAVE SHADE CONTROL HOW TOThis article will walk you through the shade installation as well as how to add the shade to your SmartThings hub. Looking to control some shades with Z-Wave? Worthington Distribution has a solution using a Somfy standard, 4-wire, AC motor with Zipato’s Micromodule Motor Controller. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |